D-Link xStack DGS-3600 Series User Manual - Port Bandwidth
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Port Bandwidth
The bandwidth control settings are used to place a
ceiling on the transmitting and receiving data rates
for any selected port. In the
QoS
folder, click
Bandwidth Control
, to view the window shown to
the left.
The following parameters can be set or are
displayed:
Parameter Description
From/To
A consecutive group of ports
may be configured starting with
the selected port.
Type
This drop-down menu allows
you to select between
RX
(receive),
TX
(transmit), and
Both
. This setting will determine
whether the bandwidth ceiling is
applied to receiving,
transmitting, or both receiving
and transmitting packets.
No Limit
This drop-down menu allows
you to specify that the selected
port will have no bandwidth limit.
Enabled
disables the limit.
Rate
This field allows the user to
enter the data rate, in
increments of 64 Kbits per
second, that will be the limit for
the selected port. For example,
in the adjacent window, port one
has been set as 100. This
translates to 6400Kbits/sec. The
default setting is
No Limit.
Figure 9- 2. Bandwidth Settings window
Click
Apply
to set the bandwidth control for the selected ports. Results of configured Bandwidth Settings will be displayed in the
Port Bandwidth Table
.
173