E.H. Wachs 08-051-MAN User Manual - page 13
Manual is about: Subsea Wire Saw
of
84
Chapter 1, About the Subsea Wire Saw: Equipment Description
E.H. Wachs
Part No. 08-051-MAN, Rev. 1-0709
9
Figure 1-8. The front mounting shoes are shown.
Topside Control Panel
Figure 1-9 illustrates the controls used to operate the subsea
wire saw. Chapter 3 includes detailed instructions.
Figure 1-9. The photo shows the controls on the top-
side control unit. (The fourth circuit, to the far right, is
not used with the subsea wire saw.)
Clamp pressure gauges
Clamp
direction
Cutter
speed
Cutter pressure gauge
Feed speed
Feed pressure gauge
Feed
direction
Clamping flow levers (engage
both at once—shown closed
under pressure)
Feed flow lever
(shown open)
Cutter flow lever
(shown open)