E.H. Wachs 08-051-MAN User Manual - page 53
Chapter 4, Maintenance: Replacing the Wheel Liners
E.H. Wachs
Part No. 08-051-MAN, Rev. 1-0709
49
Figure 4-18. Remove the nut (on the bottom) of the
tension rod mounting bolt, and remove the bolt.
4.
Remove the hub bolt and spacer bolt from the wheel
assembly, as shown in Figure 4-18. Be careful not to
lose the spacer.
5.
Pull the top plate off the wheel.
6.
Pull the wheel up off the motor shaft. Note the side of
the wheel that mounts onto the motor; the wheel is not
reversible.
7.
Disassemble the wheel and replace the liner as
described in the previous section, “Tension and Idler
Wheels”.
8.
Replace the wheel on the motor shaft, making sure the
correct side is toward the motor.
9.
Replace the top plate. Insert the spacer bolt through
the spacer and snug it down.
10.
Replace the hub bolt and snug it.
11.
Replace the tension rod mounting bolt through the
plates and tension rod end. Put the nut on the end of
the bolt and tighten it securely.
12.
Tighten the spacer bolt and hub bolt securely.
Tension rod
mounting bolt
Hub bolt
Spacer bolt
Top plate