E.H. Wachs 08-051-MAN User Manual - page 54
Manual is about: Subsea Wire Saw
of
84
Subsea Wire Saw User’s Manual
50
Part No. 08-051-MAN, Rev. 1-0709
E.H. Wachs
13.
Slide the wheel and motor assembly plates into place
in the saw bow and line up the pivot pin holes.
14.
Set the stop collars in place between the plates. Insert
the pivot pin through the top plate, the stop collars,
and the bottom plate.
15.
Holding the pivot pin in place, position the stop col-
lars against the mounting plates and tighten the set
screws.
Figure 4-19. Make sure the pivot pin is through both
plates, then position the stop collars and tighten the
set screws.
Pivot pin
Stop collars
Set screw