E.H. Wachs 08-051-MAN User Manual - page 14
Manual is about: Subsea Wire Saw
of
84
Subsea Wire Saw User’s Manual
10
Part No. 08-051-MAN, Rev. 1-0709
E.H. Wachs
Rigging the Machine
A rigging instruction label is attached to the top of the
machine frame.
Figure 1-10. The rigging label is on top of the frame.
Lifting for Vertical Cut
Attach the machine to the lifting device using chains on the
top lift hooks. Tip the machine up to a vertical position, then
pick it up. Make sure the chains are the appropriate length to
hold the machine reasonably straight.
Figure 1-11. To position the machine vertically on the
pipe, attach to the two top lift hooks.
IMPORTANT: Do not attach to this hook
when lifting the machine vertically!