E.H. Wachs 08-051-MAN User Manual - page 8
Subsea Wire Saw User’s Manual
4
Part No. 08-051-MAN, Rev. 1-0709
E.H. Wachs
Separate controls and gauges for each circuit are provided
on the TCP, described later in this chapter.
Subsea Wire Saw Models
The model name indicates
the pipe size capacity. The
first two digits are the largest
pipe, and the second pair of
digits is the smallest. For
example, the WS-3616 saw
will cut pipes from 16” to 36”
(406 to 914 mm) O.D.
Various wire saw models are available, each designed to cut
a range of pipe sizes. The only significant difference in the
models is size; all operate in a similar manner. The follow-
ing table lists the models and capacities.
Cutting Wire Drive System
The cutting wire drive system consists of four wheels
mounted on the bow of the machine. Figure 1-1 illustrates
the drive system components.
Figure 1-1. The photo shows the cutting wire drive
system components.
NOTE
Table 1: Subsea Wire Saw Models
Model
Min. Pipe
Capacity
Max. Pipe
Capacity
WS-3012
12” (305 mm)
30” (762 mm)
WS-3616
16” (406 mm)
36” (914 mm)
WS-5230
30” (762 mm)
52” (1321 mm)
Idler wheels
Drive wheel
Tension wheel
Diamond wire
Tensioning knob
Tension spring