E.H. Wachs 08-051-MAN User Manual - page 44
Manual is about: Subsea Wire Saw
of
84
Subsea Wire Saw User’s Manual
40
Part No. 08-051-MAN, Rev. 1-0709
E.H. Wachs
Figure 4-2. Grease the feed components shown at the
top of the feed system.
3.
Pump AquaLube into the grease fitting on the feed
screw mount at the bottom of the screw.
Figure 4-3. Grease the fitting at the bottom of the feed
screw.
4.
Pump AquaLube into the grease fittings on the cylin-
der rod ends until grease is visible.
Feed block
Feed motor
Feed gears