E.H. Wachs 08-051-MAN User Manual - page 37
Chapter 3, Operating Instructions: Performing the Cut
E.H. Wachs
Part No. 08-051-MAN, Rev. 1-0709
33
At the minimum operating
speed, the drive wheel will be
spinning at about 1500 RPM.
5.
Start with the cutting speed knob at 18 gpm. Visually
ensure that the wheels are spinning.
Figure 3-14. Push the cutting speed knob up to
increase the drive wheel speed.
6.
Push the feed flow lever down to start feeding the wire
into the pipe. The feed speed knob should be at 2.5
gpm.
7.
As the wire enters the cut, increase the cutting speed
by moving the cutting speed knob. Do not go above 19
gpm.
8.
During cutting, the feed control actuator on the ten-
sion wheel fixture adjusts the feed rate to keep the saw
from overfeeding. It should not be necessary to adjust
the feed rate at the TCP.
The feed drive will travel
about 2 inches beyond the
bottom of the largest pipe
size.
9.
Continue until the wire has completely severed the
pipe.
10.
Pull the feed flow lever up to turn off the feed drive.
NOTE
NOTE