E.H. Wachs 08-051-MAN User Manual - page 47
Chapter 4, Maintenance: Replacing the Mounting Shoes
E.H. Wachs
Part No. 08-051-MAN, Rev. 1-0709
43
5.
Turn the drive wheel tension knob until the wire starts
to tighten and stays on the wheels.
6.
To prepare the machine for a new cut, set the wire ten-
sion as described in the operating instructions in
Chapter 3.
R
EPLACING
THE
M
OUNTING
S
HOES
You may have to replace the mounting shoes if they are
damaged or worn. Four screws attach each shoe to the
frame.
Figure 4-9. The four screws indicated hold the shoe to
the machine frame.
1.
Remove the nuts on the four screws holding the shoe
in place.
2.
Remove the shoe.
3.
Put the new shoe in place and replace the screws.
4.
Replace the nuts and tighten them securely.
R
EPLACING
THE
W
HEEL
L
INERS
The liners on the cutting wire wheels are durable and long-
lasting. They may wear out after extensive use, or be dam-