E.H. Wachs 08-051-MAN User Manual - page 41
Manual is about: Subsea Wire Saw
of
84
Chapter 3, Operating Instructions: Removing the Machine
E.H. Wachs
Part No. 08-051-MAN, Rev. 1-0709
37
Figure 3-21. Set the clamping direction knob to
RETRACT.
7.
Push both clamping flow levers down simultaneously
until the clamp arms are fully open. The right (return
pressure) gauge reading will equal the system pres-
sure. Pull the clamping flow levers back up.
8.
Lift the machine off the pipe. Move it to the next cut-
ting location or bring it topside if you are finished.