E.H. Wachs 08-051-MAN User Manual - page 33
Chapter 3, Operating Instructions: Connecting the Hydraulic Hoses
E.H. Wachs
Part No. 08-051-MAN, Rev. 1-0709
29
3.
Insert the forked pin through the back of the machine.
Figure 3-9. Insert the forked pin through the hole pair
for the pipe size range (in this case, 46-52”) you are
cutting.
4.
Insert the spring clips in the forked pin on the front of
the machine.
Make sure both clamping
arms are set at the same
position. If they are not the
same, the machine may not
clamp securely on the pipe.
Damage to the machine
could result.
5.
Set the position of the other clamp arm to the same
location.
C
ONNECTING
THE
H
YDRAULIC
H
OSES
Connect the hydraulic hoses from the topside control panel
(TCP) to the hydraulic bulkhead on the machine, as indi-
cated in Figure 3-10.
CAUTION