E.H. Wachs 08-051-MAN User Manual - page 29
Chapter 3, Operating Instructions: Setting the Clamp Arms for the Pipe Size
E.H. Wachs
Part No. 08-051-MAN, Rev. 1-0709
25
Figure 3-4. When you push the wire to deflect it, the
actuator rod will extend.
S
ETTING
THE
C
LAMP
A
RMS
FOR
THE
P
IPE
S
IZE
The clamp arms are attached to the main frame using forked
pins that go through two holes in the frame. Multiple sets of
holes allow the arms to be mounted in five positions.
The hole pairs for each position are stamped with the size of
the largest pipe for that position. Refer to the following sec-
tions for the pipe size settings for each saw model.
WS-3012 Pipe Size Settings
Table 1 and Figure 3-5 describe the pipe size settings for the
WS-3012 model.
Table 1: Pipe Size Ranges for Clamping
Arm Positions—WS-3012
Size Stamp
Pipe Diameter Range
14
12” to 14” (305-356 mm)
18
14” to 18” (356-457 mm)
22
18” to 22” (457-559 mm)