E.H. Wachs 08-051-MAN User Manual - Chapter 3

Chapter 3, Operating Instructions

E.H. Wachs 

Part No. 08-051-MAN, Rev. 1-0709

23

Chapter 3

Operating 

Instructions

T

ENSIONING

THE

 C

UTTING

 W

IRE

You should have the wire installed according to the mainte-

nance instructions in Chapter 4.

1.

At the tension wheel fixture, check the start lines on 

the feed control actuator. When there is no tension on 

the wire, the actuator rod will be retracted and the 

start lines will be offset.

Figure 3-1.  With no tension on the wire, the feed 

actuator start lines will be offset.

In This Chapter

T

ENSIONING

THE

 C

UTTING

W

IRE

S

ETTING

THE

 C

LAMP

 A

RMS

FOR

THE

 P

IPE

 S

IZE

C

ONNECTING

THE

 H

YDRAULIC

H

OSES

M

OUNTING

THE

 M

ACHINE

ON

THE

 P

IPE

P

ERFORMING

THE

 C

UT

R

EMOVING

THE

 M

ACHINE