Jablotron JA-63 „PROFI“ Installation Manual - page 4
JA-63 „PROFI“ Alarm System
- 4 -
MGK51404
This product should be installed by professional installers. The manufacturer assumes no liability for damages caused by
incorrect installation or improper use of this system.
1 Architecture of the control panel
The JA-63 "Profi" is a fully programmable control panel with building block architecture. By programming, it can be split
into two separately operated sections (with a shared section). It has a built in power supply and there is ample space for a
back up battery (12V, 1.3Ah or 2.6Ah) in the control panel case.
The JA-63K main board has 4 hard-wired inputs with programmable triggering (NC, balanced or double balanced)
and programmable reactions.
Model JA-63KR (equipped with the “R” radio communicating module) has 16 wireless zones. Up to two JA-60 detectors can
enrolled into each zone (totally 32 as a maximum). In total model 63KR has 20 zones (4 wired and 16 wireless). Up to 8
wireless controllers (remote controls or wireless keypads), a JA-60A wireless siren and unlimited number of UC family
wireless output modules can be enrolled as well. If more zones are required, another JA-6x control panel can be enrolled
as a subsystem (Master & Slave architecture). The master control panel receives information from the sub control panel
and it can also arm and disarm the subsystem panel.
Telephone module “X” can communicate with a Monitoring Station, send two voice messages, send five SMS
messages via SMS server (or dial a numeric Pager) or. It can also communicate with a remote PC (using ComLink SW
and a JA-60U modem).
GSM dialer JA-60GSM sends SMS messages, calls to predefined telephone numbers and plays audible warning,
communicates with 2 CMS, allows remote access from a phone’s keypad and can be set via web page.
Operation and programming is possible via the JA-60E keypad (either directly wired to the control panel or remotely
using JA-60U modem). The control panel equipped with a radio module (63KR, 63KRX) can also be programmed and
operated by a JA-60F wireless keypad and can also be operated by RC-11, RC-22 or RC-60 remote controls or by a JA-
60D wireless keypad. Operation and programming is also possible via a PC using ComLink SW (locally or remotely via
JA-60U modem).
the internal layout
Available models of the JA-63 system
control panel
R
module
X
module
GSM
module
description
JA-63K
no
no
no
four zone hard wired control panel
JA-63KR
yes
no
no
16 zones wireless (up to 32 detectors) & 4 hard wired zones
JA-63KRX
yes yes no
16 zones wireless (up to 32 detectors) & 4 hard wired zones & digital
telephone communicator.
JA-63KRG
yes
no
yes
16 zones wireless (up to 32 detectors) & 4 hard wired zones & GSM dialer.
Note: Radio module R can not be ”aftermarket” installed into 63K and 63KX models. Telephone communicator X module and GSM dialer JA-60GSM can be
installed additionally to a 63K or 63KR control panels.