Panasonic Workio DP-C401 Service Handbook - page 174
3-100
Chapter 3 Troubleshooting
102-310 Send Queue Full
[Detection Conditions]
Sending queue full
Over the upper limit of the processing capability to
send data from the Panel to the Controller.
[Actions] Perform re-installation of the software.
102-311 Receive Queue Full
[Detection Conditions]
Receive queue full.
The data received from the Controller exceeded the
upper limit of the processing capability in the Panel.
[Actions] Perform re-installation of the software.
102-312 EVM Uses Wrong API
[Detection Conditons] Illegal use of API by EVM
[Actions] Perform re-installation of the software.
102-313 AS Uses Wrong API
[Detection Conditons] Illegal use of API by AS
[Actions] Perform re-installation of the software.
102-314 Wait Event Time Out
[Detection Conditions]
Time-Out of the event waiting timer
The response message from the Controller was not
notified for a specified time.
[Actions] Perform re-installation of the software.
102-315 CTS Internal Failure
[Detection Conditions] CTS Internal Error
[Actions] Perform re-installation of the software.
102-316 Send Request Queue Full SIO
[Detection Conditions]
Sending Request Queue Full (SIO)
Over the upper limit of the processing capability to
send data from the Panel to the Controller.
[Actions] Perform re-installation of the software.
102-317 Receive Message Queue Full
[Detection Conditions]
Receive message queue full.
The data received from the Controller exceeded the
upper limit of the processing capability in the Panel.
[Actions] Perform re-installation of the software.
102-318 Receive Finish Queue Full
[Detection Conditions]
Receiving completion queue full
The data received from the Controller exceeded the
upper limit of the processing capability in the Panel.
[Actions] Perform re-installation of the software.
102-319 Send Failure with No ACK
[Detection Conditions]
Sending failure (ACK was not returned.)
Serial communication failure
[Actions] Perform re-installation of the software.
102-320 Polling Failure
[Detection Conditions]
Communication failure (polling error)
Serial communication failure
[Actions] Perform re-installation of the software.
102-321 Send Message Failure
[Detection Conditions]
Sending message error
Serial communication failure
[Actions] Perform re-installation of the software.
102-322 Target Failure
[Detection Conditions]
Target error
Serial communication failure
[Actions] Perform re-installation of the software.
102-323 Address Failure
[Detection Conditions]
Address error
Serial communication failure
[Actions] Perform re-installation of the software.
102-324 Size Failure
[Detection Conditions]
Size error
Serial communication failure
[Actions] Perform re-installation of the software.
102-325 Object Creation Failure
[Detection Conditions]
Object creation error
The specified object failed to be created due to a
setting or specifying error on gm_create.
[Actions] Perform re-installation of the software.