Panasonic Workio DP-C401 Service Handbook - page 252
3-178
Chapter 3 Troubleshooting
Turn On the document exchange command signal to the DADF
On: Low
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: -
[Reference BSD]: CH5.2
29. 007-003
SMH FEED Clutch
[PSW Display]: SMH FEED Clutch
[Operation Description]:
On
On: Low
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: -
[Reference BSD]: CH8.1
30. 007-004
HOTLINE_TRAY
[PSW Display]: HOTLINE_TRAY
[Operation Description]:
Not used.
On: -
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: -
[Reference BSD]: -
31. 008-001
#1Feed Motor (Fwd)
[PSW Display]: #1Feed Motor (Fwd)
[Operation Description]:
Feed (Rotate #1Feed Motor in paper feed direction at 200mm/sec)
On: Every 4 phase High/Low toggling
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: 8-002
[Reference BSD]: CH7.5
32. 008-002
#1Feed Motor (Rev)
[PSW Display]: #1Feed Motor (Rev)
[Operation Description]: Lift Up
It turns Off automatically 6sec after Lift Up has started, or when the Level Senser
detected Lift Up.
On: Every 4 phase H/L toggling
[T-ON]: On
[Cycle]: Off
[Multiple Output Prohibited Items]: 8-001
[Reference BSD]: CH7.5
33. 008-003
#2Feed Motor (Fwd)
[PSW Display]: #2Feed Motor (Fwd)
[Operation Description]:
Feed (Turn #2Feed Motor On in paper feed direction at 192mm/sec)
On: -
[T-ON]: Off
[Cycle]: Off
[Multiple Output Prohibited Items]: 8-004
[Reference BSD]: CH7.6
34. 008-004
#2Feed Motor (Rev)
[PSW Display]: #2Feed Motor (Rev)
[Operation Description]: Lift Up
It turns Off automatically 6sec after Lift Up has started, or when the Level Senser
detected Lift Up.
On: -
[T-ON]: On
[Cycle]: Off
[Multiple Output Prohibited Items]: 8-003
[Reference BSD]: CH7.6
Lift Up cannot be performed when the Level Snr should detect Lift Up.
Lift Up cannot be performed when the Level Snr should detect Lift Up.