Panasonic Workio DP-C401 Service Handbook - page 176
3-102
Chapter 3 Troubleshooting
102-337 Frame Data Error with Invalid Data Type
[Detection Conditions]
Invalid frame data was detected.
The incorrect value of the Data Type detected by
Frame ID was detected.
[Actions]
Check the D-RAM and ROM. Replace the Control
Panel. (PL16.2)
Perform re-installation of the software.
102-338 Frame Data Error Offset Address Out of Scope
[Detection Conditions]
Invalid frame data was detected.
The Offset Address out of range was extracted from
the Frame ID.
[Actions]
Check the D-RAM and ROM. Replace the Control
Panel. (PL16.2)
Perform re-installation of the software.
102-339 Display Request Code Invalid
[Detection Conditions]
Text Code failure
The system detected that the Code requested to be
displayed was incorrect.
[Actions]
Check the D-RAM and ROM. Replace the Control
Panel. (PL16.2)
Perform re-installation of the software.
102-340 Interface Failure GUAM - DM I/F
[Detection Conditions]
Interface failure
Incorrect parameter was detected at the I/F between
the GUAM and DM.
[Actions]
Check the D-RAM and ROM. Replace the Control
Panel. (PL16.2)
Perform re-installation of the software.
102-341 Event Queue Full
[Detection Conditions] Event queue full
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-342 Event Queue Empty
[Detection Conditions] Event queue empty
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-343 Invalid Class
[Detection Conditions] Invalid class
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-344 Invalid Type
[Detection Conditions] Invalid type
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-345 Timer Queue Full
[Detection Conditions] Timer queue full
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-346 Invalid Timer Number
[Detection Conditions] Invalid timer number
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-347 Undefined Trap
[Detection Conditions] Undefined trap
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-348 Command Access Exception
[Detection Conditions] Exceptional command access
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-349 Invalid Command
[Detection Conditions] Illegal command
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)