Panasonic Workio DP-C401 Service Handbook - page 178
3-104
Chapter 3 Troubleshooting
102-366 Reserve Function Code
[Detection Conditions] Code number for reserve function
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-367 Unsupported Function
[Detection Conditions] Unsupported function
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-368 Short of UI Memory
[Detection Conditions] Insufficient memory, or connection
failure
[Actions]
Perform re-installation of the software.
Or replace the CONTROL PANEL. (PL16.2)
102-369 Invalid Interface Value
[Detection Conditions]
Invalid interface value
Panel-SW failure
[Actions] Perform re-installation of the software.
102-370 Interface Length Failure
[Detection Conditions]
Interface length failure
The parameter notified from the Controller was incorrect.
[Actions] Perform re-installation of the software.
102-371 Interface Parameter Failure
[Detection Conditions]
Interface parameter failure
The parameter notified from the Controller was incorrect.
[Actions] Perform re-installation of the software.
102-372 Interface Sequence Failure
[Detection Conditions]
Interface sequence failure
The initial command from the Controller was not
notified for a specified time.
[Actions] Perform re-installation of the software.
102-373 Channel Failure
[Detection Conditions]
Channel failure
The channel notified from the Controller was incorrect.
[Actions] Perform re-installation of the software.
102-374 Invalid User Job ID
[Detection Conditions]
Incorrect User Job ID
The Job ID parameter notified from the Controller was
incorrect.
[Actions] Perform re-installation of the software.
102-375 Internal Resource Failure
[Detection Conditions]
Internal resource failure
Panel-SW failure
[Actions] Perform re-installation of the software.
102-376 Internal Memory Failure
[Detection Conditions]
Internal memory failure
Panel-SW failure
[Actions] Perform re-installation of the software.
102-377 UI Timer Failure
[Detection Conditions]
Timer failure
Panel-SW failure
[Actions] Perform re-installation of the software.
102-378 Interface Format Failure
[Detection Conditions]
Interface format failure
The data format notified from the Controller was
incorrect.
[Actions] Perform re-installation of the software.
102-379 Dispatch Failure
[Detection Conditions] Dispatch failure
[Actions] Perform re-installation of the software.
102-380 Copy Interface Failure
[Detection Conditions] Copy interface failure
[Actions] Perform re-installation of the software.