Xerox 721 User Manual - page 86
72
• Special features keys
XEROX WIDE FORMAT COPY SYSTEM
READY TO COPY
INSERT DOCUMENT
AUTO
1
100.0 %
Ready to Copy Screen
1. To disable the finisher, press the Finisher key again and select
BYPASS on the FOLD PROGRAM screen. The Finisher
indicator lamp is extinguished.
Below are descriptions of each of the Finisher menu options. Refer to the
Finisher user documentation for additional information on these options.
The FOLD PROGRAM feature enables you to select one of up to 20
user-defined programs. The program names are programmed into the
finisher and passed to the Controller when the finisher goes through its
power-up sequence.
FOLD PROGRAM
PROGRAM: USER PROGRAM
Fold Program Screen
The OVERLENGTH OPTIONS feature enables you to specify how long
documents (documents over 80 inches long) are handled by the folder.
The choices are NO FOLD and Z-FOLD. If NO FOLD is selected, the
long document will not be folded. If Z-FOLD is selected, the long
document will be Z-FOLDED, but not cross-folded. NO FOLD is the
factory default setting. This is not available for all finishers.
OVERLENGTH OPTIONS
OVERLENGTH: NO FOLD
Overlength Options Screen
The TAB OPTIONS feature enables you to override the pre-programmed
tab settings for the selected finishing program. The choices are
ALWAYS ON, ALWAYS OFF, and USE PROGRAM SETTING. USE
PROGRAM SETTING is the factory default setting.
Finisher menu
options
FOLD PROGRAMS
OVERLENGTH
OPTIONS
TAB OPTIONS