Xerox 721 User Manual - Sets Build Key

XEROX WIDE FORMAT COPY SYSTEM 

Special features keys  

•  75 

DON’T CARE is the factory default setting.  The settings are dependent 

on the finisher. 

OUTPUT BIN

OUTPUT BIN:      BYPASS

Output Bin Screen 

Sets Build key 

The Sets Build mode allows you to scan a series of images and build an 

electronically collated set.  Once the set is built, one or more collated 

copies can be printed. 

NOTE:  The Sets Build mode is not available unless the WIDE FORMAT 

COPY SYSTEM is in the COPY mode. 

NOTE: Any of the finishing options can be changed during a Sets Build 

job. The option(s) must be changed before the document to be copied is 

inserted. 

In Sets Build mode, documents of C (A2) size, and larger, are normally 

delivered to the rear of the Scan System after the scan.  If the 

DOCUMENT RETURN parameter is set to REAR, then all documents 

are delivered to the rear after scanning.  The WIDE FORMAT SCAN 

SYSTEM is equipped with a document catching device, called the 

Stacker, to receive these documents.  Refer to “Scan System Control” in 

the “Main Menu” section of this manual for further information about the 

DOCUMENT RETURN parameter. 

To build a collated set: 

1. Press 

the 

Sets Build

 key.  The Sets Build indicator lamp 

illuminates and the SETS BUILD screen is displayed. This 

screen enables you to select the desired collation method, to 

select whether or not to print checkplots, and to begin the 

accumulation of the documents to create the set. 

SETS BUILD

  COLLATION:      FORWARD

9

CHECKPLOT

Sets Build Screen 

2. Press 

the 

Previous

 or the Next key to select FORWARD or 

REVERSE collation. 

Preparing to build the 

set 

Building and printing 

the set