Baldor NXE100-1608Dx Installation manual - page 10
www.baldormotion.com
2-2 Introduction
MN1941
Included with NextMove e100 is the Baldor Motion Toolkit CD. This contains a number of utilities
and useful resources to get the most from your Mint controller. These include:
H
Mint WorkBench
This is the user interface for communicating with the NextMove e100. Installing Mint
WorkBench will also install firmware for NextMove e100.
H
Mint Machine Center
This is used to view and configure a multi-axis network of connected controllers.
H
PC Developer Libraries
Installing Mint WorkBench will install ActiveX interfaces that allow PC applications to be
written that communicate with the NextMove e100.
This manual is intended to guide you through the installation of NextMove e100.
The chapters should be read in sequence.
The Basic Installation section describes the mechanical installation of the NextMove e100.
The following sections require knowledge of the low level input/output requirements of the
installation and an understanding of computer software installation. If you are not qualified in
these areas you should seek assistance before proceeding.
Note: You can check that you have the latest firmware and Mint WorkBench releases by
visiting the website www.baldormotion.com/supportme.