Baldor NXE100-1608Dx Installation manual - page 52
Manual is about: NextMove e100 series
Motion Controller
of
114
www.baldormotion.com
5-2 Operation
MN1941
5.1.2 Installing Mint Machine Center and Mint WorkBench
You need to install the Mint Machine Center (MMC) and Mint WorkBench. Any previous versions
of MMC or Mint WorkBench must be uninstalled before proceeding with this installation:
1. Insert the CD into the drive.
2. After a few seconds the setup wizard should start automatically. If the setup wizard does not
appear, select Run... from the Windows Start menu and type
d:\start
where d represents the drive letter of the CD device.
Follow the on-screen instructions to install MMC (including Mint WorkBench). The setup
wizard will copy the files to appropriate folders within the C:\Program Files folder, and place
shortcuts on the Windows Start menu.