Baldor NXE100-1608Dx Installation manual - page 87
Manual is about: NextMove e100 series
Motion Controller
of
114
www.baldormotion.com
Operation 5-37
MN1941
Measured position
Demand position
Figure 42 - Correct value of KPROP
The two traces will probably appear with a small offset from each other, which represents the
following error. Adjust KPROP by small amounts until the two traces appear on top of each other
(approximately), as shown in Figure 42.
Note: It may be useful to use the zoom function to magnify the end point of the move.
In the graph area, click and drag a rectangle around the end point of the traces.
To zoom out, right-click in the graph area and choose Reset Zoom.