Baldor NXE100-1608Dx Installation manual - page 11
www.baldormotion.com
Introduction 2-3
MN1941
2.2 Receiving and inspection
When you receive your NextMove e100, there are several things you should do immediately:
1. Check the condition of the packaging and report any damage immediately to the carrier that
delivered your NextMove e100.
2. Remove the NextMove e100 from the shipping container and remove all packing material. The
container and packing materials may be retained for future shipment.
3. Verify that the catalog number of the NextMove e100 you received is the same as the catalog
number listed on your purchase order. The catalog/part number is described in the next
section.
4. Inspect the NextMove e100 for external damage during shipment and report any damage to
the carrier that delivered it.
5. If the NextMove e100 is to be stored for several weeks before use, be sure that it is stored
in a location that conforms to the storage humidity and temperature specifications shown in
section 3.1.1.
2.2.1 Identifying the catalog number
Different models of NextMove e100 are available. As a reminder of which product has been
installed, it is a good idea to write the catalog number in the space provided below.
NextMove e100 catalog number:
NXE100-16___D_ or NXE100-16___S_
Installed in:
________________________
Date:
______
A description of the catalog numbers are shown in the following table:
Catalog number
Description
NXE100-1608Dx
8 axes, RS422 differential stepper outputs.
NXE100-1608Sx
8 axes, open collector (single-ended) stepper outputs.
NXE100-1612Dx
12 axes, RS422 differential stepper outputs.
NXE100-1612Sx
12 axes, open collector (single-ended) stepper outputs.
NXE100-1616Dx
16 axes, RS422 differential stepper outputs.
NXE100-1616Sx
16 axes, open collector (single-ended) stepper outputs.
Note: The x represents a letter indicating the hardware revision. This does not affect the
capabilities of the NextMove e100 unless otherwise stated.