Baldor NXE100-1608Dx Installation manual - page 36
www.baldormotion.com
4-20 Input / Output
MN1941
4.5 USB and serial communication
4.5.1 USB port
Location USB
Mating connector: USB Type B (downstream) plug
Pin Name
Description
1 VBUS
USB +5 V
2 D-
Data-
3 D+
Data+
4 GND
Ground
The USB connector is used to connect the NextMove e100 to a PC running Mint WorkBench.
The NextMove e100 is a self-powered, USB 1.1 (12 Mbps) compatible device. If it is connected
to a slower USB1.0 host PC or hub, communication speed will be limited to the USB1.0
specification (1.5 Mbps). If it is connected to a faster USB2.0 (480 Mbps) host PC or hub,
communication speed will remain at the USB1.1 specification of the NextMove e100.
Ideally, the NextMove e100 should be connected directly to a USB port on the host PC. If it is
connected to a hub shared by other USB devices, communication could be affected by the
activity of the other devices. A 2 m (6.5 ft) standard USB cable is supplied. The maximum
recommended cable length is 5 m (16.4 ft).
1
4
2
3