Jeep 2016 CHEROKEE Operating Information Manual - page 105
To Deactivate
A soft tap on the brake pedal, pushing the
CANCEL button, or normal brake pressure
while slowing the vehicle will deactivate the
Electronic Speed Control without erasing the
set speed from memory.
Pressing the ON/OFF button or turning the
ignition switch OFF erases the set speed from
memory.
To Resume Speed
To resume a previously set speed, push the
RES button and release. Resume can be used
at any speed above 20 mph (32 km/h).
To Vary The Speed Setting
To Increase Speed
When the Electronic Speed Control is set, you
can increase speed by pushing the SET
+
button.
The speed increment shown is dependant on
the chosen speed unit of U.S. (mph) or Metric
(km/h):
U.S. Speed (mph)
•
Pressing the SET
+
button once will result in
a 1 mph increase in set speed. Each subse-
quent tap of the button results in an increase
of 1 mph.
•
If the button is continually pressed, the set
speed will continue to increase until the but-
ton is released, then the new set speed will
be established.
Metric Speed (km/h)
•
Pressing the SET
+
button once will result in
a 1 km/h increase in set speed. Each subse-
quent tap of the button results in an increase
of 1 km/h.
•
If the button is continually pressed, the set
speed will continue to increase until the but-
ton is released, then the new set speed will
be established.
To Decrease Speed
When the Electronic Speed Control is set, you
can decrease speed by pushing the SET
-
button.
The speed decrement shown is dependant on
the chosen speed unit of U.S. (mph) or Metric
(km/h):
U.S. Speed (mph)
•
Pressing the SET
-
button once will result in
a 1 mph decrease in set speed. Each subse-
quent tap of the button results in a decrease
of 1 mph.
•
If the button is continually pressed, the set
speed will continue to decrease until the
button is released, then the new set speed
will be established.
Metric Speed (km/h)
•
Pressing the SET
-
button once will result in
a 1 km/h decrease in set speed. Each sub-
sequent tap of the button results in a de-
crease of 1 km/h.
•
If the button is continually pressed, the set
speed will continue to decrease until the
button is released, then the new set speed
will be established.
101