Jeep 2016 CHEROKEE Operating Information Manual - page 131
Enabling And Disabling ParkSense®
ParkSense® can be enabled and disabled with
the ParkSense® switch.
When the ParkSense® switch is
pressed to disable the system, the
instrument cluster will display the
“PARKSENSE OFF” message for
approximately five seconds. Refer
to “Driver Information Display (DID)” in “Under-
standing Your Instrument Panel” for further in-
formation. When the shift lever/gear selector is
moved to REVERSE and the system is dis-
abled, the DID will display the “PARKSENSE
OFF” message for as long as the vehicle is in
REVERSE.
The ParkSense® switch LED will be ON when
ParkSense® is disabled or requires service.
The ParkSense® switch LED will be OFF when
the system is enabled. If the ParkSense®
switch is pressed, and the system requires
service, the ParkSense® switch LED will blink
momentarily, and then the LED will be ON.
Service The ParkSense® Park Assist
System
During vehicle start up, when the ParkSense®
System has detected a faulted condition, the
instrument cluster will actuate a single chime,
once per ignition cycle, and it will display the
"
PARKSENSE UNAVAILABLE WIPE REAR SEN-
SORS
"
,
"
PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS
"
, or the
"
PARKSENSE UN-
AVAILABLE SERVICE REQUIRED
"
message for
five seconds. When the shift lever is moved to
Reverse and the system has detected a faulted
condition, the Driver Information Display (DID) will
display a
"
PARKSENSE UNAVAILABLE WIPE
REAR SENSORS
"
,
"
PARKSENSE UNAVAIL-
ABLE
WIPE
FRONT
SENSORS
"
or
"
PARKSENSE UNAVAILABLE SERVICE RE-
QUIRED
"
pop up message for five seconds. After
five seconds, a car graphic will be displayed with
"
UNAVAILABLE
"
at either the front or rear sensor
location depending on where the fault is detected.
The system will continue to provide arc alerts for
the side that is functioning properly. These arc
alerts will interrupt the
"
PARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORS
"
,
"
PARKSENSE
UNAVAILABLE WIPE FRONT SENSORS
"
, or
"
PARKSENSE UNAVAILABLE SERVICE RE-
QUIRED
"
messages if an object is detected within
the five second pop-up duration. The car graphic
will remain displayed for as long as the vehicle is
in REVERSE. Refer to “Driver Information Display
(DID)” for further information.
If
"
PARKSENSE UNAVAILABLE WIPE REAR
SENSORS
"
or
"
PARKSENSE UNAVAILABLE
WIPE FRONT SENSORS
"
appears in the
Driver Information Display (DID) make sure the
outer surface and the underside of the rear
fascia/bumper and/or front fascia/bumper is
clean and clear of snow, ice, mud, dirt or other
obstruction and then cycle the ignition. If the
message continues to appear see an autho-
rized dealer.
If the
"
PARKSENSE UNAVAILABLE SERVICE
REQUIRED
"
message appears in the DID, see
an authorized dealer.
127