Jeep 2016 CHEROKEE Operating Information Manual - page 92
Memory Position Recall
NOTE:
The vehicle must be in PARK to recall
memory positions. If a recall is attempted
when the vehicle is not in PARK, a message
will be displayed in the Driver Information
Display (DID).
Driver One Memory Position Recall
•
To recall the memory settings for driver one
using the memory switch , press MEMORY
button number 1 on the memory switch.
•
To recall the memory settings for driver one
using the RKE transmitter, press the UN-
LOCK button on the RKE transmitter linked
to memory position 1.
Driver Two Memory Position Recall
•
To recall the memory setting for driver two
using the memory switch, press MEMORY
button number 2 on the memory switch.
•
To recall the memory settings for driver two
using the RKE transmitter, press the UN-
LOCK button on the RKE transmitter linked
to memory position 2.
A recall can be cancelled by pressing any of the
MEMORY buttons during a recall (S, 1, or 2).
When a recall is cancelled, the driver’s seat,
steering column (if equipped) and pedals (if
equipped) stop moving. A delay of one second
will occur before another recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver seat po-
sitioning to enhance driver mobility when enter-
ing and exiting the vehicle.
The distance the driver seat moves depends on
where you have the driver seat positioned when
you cycle the vehicles ignition to the OFF
position.
•
When you cycle the vehicles ignition to the
OFF position, the driver seat will move about
2.4 in (60 mm) rearward if the driver seat
position is greater than or equal to 2.7 in
(67.7 mm) forward of the rear stop. The seat
will return to its previously set position when
you cycle the vehicles ignition to the ACC or
RUN position.
•
The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than
0.9 in (22.7 mm) forward of the rear stop. At
this position, there is no benefit to the driver
by moving the seat for Easy Exit or Easy
Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled
when the vehicle is delivered from the fac-
tory. The Easy Entry/Exit feature is enabled
(or later disabled) through the program-
mable features in the Uconnect® system.
Refer to “Uconnect® Settings/Customer
Programmable Features” in “Understanding
Your Instrument Panel” for further informa-
tion.
88