Jeep 2016 CHEROKEE Operating Information Manual - page 210
7. Passenger Temperature Control Up But-
ton (Uconnect® 8.4 Radio Only)
Provides the passenger with independent tem-
perature control. Push the button on the face-
plate for warmer temperature settings or on the
touchscreen, press and slide the temperature
bar towards the red arrow button on the touch-
screen for warmer temperature settings.
NOTE:
Pressing this button while in Sync mode will
automatically exit Sync.
8. Passenger Temperature Control Down
Button (Uconnect® 8.4 Radio Only)
Provides the passenger with independent tem-
perature control. Push the button on the face-
plate for cooler temperature settings or on the
touchscreen, press and slide the temperature
bar towards the blue arrow button on the touch-
screen for cooler temperature settings.
NOTE:
Pressing this button while in Sync mode will
automatically exit Sync.
9. SYNC
Press the Sync button on the touchscreen to
toggle the Sync feature On/Off. The Sync indi-
cator is illuminated when this feature is enabled.
Sync is used to synchronize the passenger
temperature setting with the driver temperature
setting. Changing the passenger temperature
setting while in Sync will automatically exit this
feature.
10. Blower Control
Blower control is used to regulate the amount of
air forced through the climate system. There are
seven blower speeds available. Adjusting the
blower will cause automatic mode to switch to
manual operation. The speeds can be selected
using either the blower control knob on the
faceplate or buttons on the touchscreen as
follows:
Blower Control Knob On The Faceplate
The blower speed increases as you turn the
control clockwise from the lowest blower set-
ting. The blower speed decreases as you turn
the knob counter-clockwise.
Button On The Touchscreen
Use the small blower icon to reduce the blower
setting and the large blower icon to increase the
blower setting. Blower can also be selected by
pressing the blower bar area between the icons.
11. Modes
The airflow distribution mode can be adjusted
so air comes from the instrument panel outlets,
floor outlets, demist outlets and defrost outlets.
The Mode settings are as follows:
Panel Mode
Air comes from the outlets in the
instrument panel. Each of these
outlets can be individually ad-
justed to direct the flow of air. The air vanes
of the center outlets and outboard outlets
can be moved up and down or side to side
to regulate airflow direction. There is a shut
off wheel located below the air vanes to
shut off or adjust the amount of airflow from
these outlets.
206