Jeep 2016 CHEROKEE Operating Information Manual - page 109
To turn the system OFF, push and release the
Adaptive Cruise Control (ACC) ON/OFF button
again. At this time, the system will turn off and
the DID will display “Adaptive Cruise Control
(ACC) Off.”
WARNING!
Leaving the Adaptive Cruise Control (ACC)
system on when not in use is dangerous. You
could accidentally set the system or cause it
to go faster than you want. You could lose
control and have a collision. Always leave
the system off when you are not using it.
To Set A Desired ACC Speed
When the vehicle reaches the speed desired,
push the SET
+
button or the SET
-
button and
release. The DID will display the set speed.
If the system is Set when the vehicle speed is
below 20 mph (32 km/h), the Set Speed shall be
defaulted to 20 mph (32 km/h). If the system is
Set when the vehicle speed is above 20 mph
(32 km/h), the Set Speed shall be the current
speed of the vehicle.
NOTE:
ACC cannot be set if there is a stationary
vehicle in front of your vehicle in close
proximity.
Remove your foot from the accelerator pedal. If
you do not, the vehicle may continue to accel-
erate beyond the set speed. If this occurs:
•
The message “DRIVER OVERRIDE” will dis-
play in the DID.
•
The system will not be controlling the dis-
tance between your vehicle and the vehicle
ahead. The vehicle speed will only be deter-
mined by the position of the accelerator
pedal.
To Cancel
The following conditions cancel the system:
•
The brake pedal is applied.
•
The CANCEL button is pressed.
•
An Anti-Lock Brake System (ABS) event
occurs.
•
The shift lever/gear selector is removed from
the Drive position.
•
The Electronic Stability Control/Traction Con-
trol System (ESC/TCS) activates.
•
The vehicle parking brake is applied.
•
Driver seatbelt is unbuckled at low speeds.
•
Driver door is opened at low speeds.
•
A Trailer Sway Control (TSC) event occurs.
•
The driver switches ESC to full-off mode.
Adaptive Cruise Control Off
105