Jeep 2016 CHEROKEE Operating Information Manual - page 162
CAUTION!
(Continued)
desirable system operation or sensor dam-
age may result when using replacement
equipment that is not of the same size, type,
and/or style. Aftermarket wheels can cause
sensor damage. Do not use tire sealant from
a can or balance beads if your vehicle is
equipped with a TPMS, as damage to the
sensors may result.
16. Driver Information Display (DID)
The odometer display shows the total distance
the vehicle has been driven.
When the appropriate conditions exist, this
Driver Information Display (DID) messages. Re-
fer to “Driver Information Display” of your own-
ers manual for more information.
17. Selectable DID Menu
This area of the cluster will display the DID
selectable menu. For further information, refer
to “Driver Information Display (DID)” in this
section.
18. Air Bag Warning Light
This light will turn on for four to
eight seconds as a bulb check
when the ignition switch is first
turned to the ON/RUN position. If
the light is either not on during
starting, stays on, or turns on while driving, have
the system inspected at an authorized dealer as
soon as possible. Refer to “Occupant Re-
straints” in “Things To Know Before Starting
Your Vehicle” of your owners manual for further
information.
19. Vehicle Security Light
This light will flash rapidly for ap-
proximately 15 seconds when the
vehicle security alarm is arming.
The light will flash at a slower
speed continuously after the alarm
is set. The security light will also come on for
about three seconds when the ignition is first
turned on.
20. Electronic Stability Control (ESC) OFF
Indicator Light — If Equipped
This light indicates the Electronic
Stability Control (ESC) is off.
21. Electronic
Stability
Control
(ESC)
Activation/Malfunction Indicator Light — If
Equipped
The “ESC Activation/Malfunction
Indicator Light” in the instrument
cluster will come on when the igni-
tion switch is turned to the ON/
RUN position. It should go out with
the engine running. If the “ESC Activation/
Malfunction Indicator Light” comes on continu-
ously with the engine running, a malfunction
has been detected in the ESC system. If this
light remains on after several ignition cycles,
and the vehicle has been driven several miles
(kilometers) at speeds greater than 30 mph
(48 km/h), see your authorized dealer as soon
as possible to have the problem diagnosed and
corrected.
158