NEC SA2500 User Manual - Caution
User Guide
103
www.nec-computers.com
RAID Configuration using the SCSISelect Utility
Installing the Hard Disk Drives
Install the required SCSI hard disk drives to your system.
Caution
■
Use two hard disk drives of the same revolution (rpm).
■
To configure RAID 1, use also two hard disk drives of the
same capacity.
Enabling the RAID Feature using the SCSISelect Utility
Two or more of the installed hard disk drives can be used either as a single disk or a
RAID drive.
Note: The factory-set value is to use the hard disk drive as
a single disk drive.
To configure a disk drive connected to the onboard SCSI connector with the
SCSISelect Utility:
1. Start the SCSISelect Utility. See
“Running the SCSISelect Utility” on
page 168
.
AIC-7902 A at Slot 23 02:03:00
AIC-7902 B at Slot 23 02:03:01