NEC SA2500 User Manual - Warning
User Guide
84
www.nec-computers.com
3. Remove the screw (E) holding the power supply bracket.
4. Remove the bracket (F) by pulling the top toward you and disengaging the
bottom.
Warning
Put on protective gloves before you follow the instructions
below. The power modules are very hot and there is a risk of
severe burns.
5. Press the clips (C) from the relevant power module, and slide the module out of
the chassis.
6. Slide in the new power module, and press it firmly until it clicks into place.
7. Plug the power cord on the power outlet and on the module (B).
8. Switch on the module (A), its LED (D) should light green.
9. Replace the bracket (F) by engaging the bottom first, and then pushing the top
towards the chassis.
10. Secure the bracket using the screw (E) removed in step 2