NEC SA2500 User Manual - page 82
of
253
User Guide
79
www.nec-computers.com
3. Install the rack mounting frame (A) on the server (B) as shown in figure 4
below.
Figure 11: Installing the rack mounting frame on the server
4. Slide the rack mounting frame on the server until the front of the server
protrude a little from the frame.
5. Replace the front panel.
6. Replace the right side door.
7. Align the rack mounting frame (A in figure 5) with the rear of the front panel
(B in figure 5).
8. Secure the frame with the grubscrews (C in figure 5, four on each side) using
the hex key (C in figure 1), enough to fix the frame to the server but not too
much to prevent damage to the server case.
Figure 12: Securing the rack mounting frame