NEC SA2500 User Manual - Preparing Scsi Devices
of
253
User Guide
157
www.nec-computers.com
Preparing SCSI Devices
Preparing a SCSI Hard Disk Drive
Before installing a SCSI hard disk drive in the system, it should be set as ID0, ID1, ID2
or ID3.
Refer to the instructions printed on the device for further jumper setting information.
Preparing a SCSI Tape Drive
Before installing a SCSI tape drive in the system, it should be set as ID4.
Refer to the instructions printed on the device for further jumper setting information.