NEC SA2500 User Manual - page 216
User Guide
213
www.nec-computers.com
Primary IDE Master Submenu
Table 24: Primary IDE Master Submenu
Feature
Choices or
Display Only
Description
Your Setting
Primary IDE Master
Auto
None
Manual
When set to Auto, the hard
drive is automatically detected
and the BIOS fills in the correct
values for the fields below.
Set to Manual to specify hard
disk drives parameters.
Set to None if no hard drive is
installed.
Access Mode
Auto
CHS
LBA
Large
Set to Auto to allow the
automatic detection of an IDE
hard disk drive.
When Primary IDE Master
(above) is set to Manual, set
the relevant access mode
configuration option.
Capacity
Display Only
Cylinder
Display Only
Head
Display Only
Precomp.
Display Only
Landing Zone
Display Only
Sector
Display Only
PIO Mode
Auto
Mode 0
Mode 1
Mode 2
Mode 3
Mode 4
Sets the PIO mode for the IDE
device.
UDMA Mode
Auto
Disabled
When set to Auto, the UDMA
capability allows improved
transfer speeds and data
integrity for supported IDE
devices.
Transfer Rate
Display Only
S.M.A.R.T Status
Display Only