NEC SA2500 User Manual - page 130
User Guide
127
www.nec-computers.com
aligned with those on the device. (Additional screws are secured to the bottom
of the 5.25-inch cage visible side.)
Figure 19: Attaching the Slide Rails
6. Slide in the 5.25-inch device until it clicks into place.
7. Connect the data cable to the device with the marked edge toward pin 1 of the
drive.
See “Cabling IDE Devices” on page 148.
8. Connect the power cable to the drive.
See “Cabling IDE Devices” on
page 148.
9. Replace the front panel.
See “Replacing the Front Panel” on page 125.
10. Replace the right side door.
See “Replacing the Right Side Door” on page 124.
Note: If necessary, modify the BIOS Setup program to
recognise the additional device. For additional information, refer
to
“BIOS Setup Utility” on page 210
.
Removing a 5.25-inch device
1. Remove the right side door.
See “Removing the Right Side Door” on page 122.
2. Remove the front panel.
See “Removing the Front Panel” on page 125.
3. Disconnect the power cable and the data cable from the 5.25-inch device.
4. Press both slide rails ends to release the 5.25-inch device
5. Pull the 5.25-inch device out of the frame.
6. Replace the front panel.
See “Replacing the Front Panel” on page 125.
7. Replace the right side door.
See “Replacing the Right Side Door” on page 124.