NEC SA2500 User Manual - page 142
User Guide
139
www.nec-computers.com
11. Gently apply pressure equally over the top surface of the processor until it seats
in the socket. The processor should fit, do not force the processor into the
socket. Push the socket lever down until it snaps into the locked position.
12. Install the heatsink proceeding as follows:
■ On one side of the heatsink, insert the metal arm notches into the
corresponding slots. Push on the heatsink until the hear a click when the
other arm is in place.
■ Secure the heatsink to the system by pushing the two plastic arms down.
Note: Make sure that the heatsink is level.
13. Connect the fan cable to the processor fan connector on the motherboard.
14. Replace the front panel.
See “Replacing the Front Panel” on page 125.
15. Replace the right side door.
See “Replacing the Right Side Door” on page 124.