Oce im5530 Printing Manual - page 240

5 Printing from Windows

238    Setting Up Print Options

10) Hole Punch

This sets whether a print job is printed with hole punches.

- None — Select this to print without hole punches.

- Center Top — Select this to create holes along the top edge and print.

- Middle Left — Select this to create holes along the left side and print.

y

 “None” can only be selected if a hole punch unit is not installed.

y

 “None” can only be selected when the Booklet printing is set at the Layout tab.

11) 2-Sided Printing

This sets 2-Sided printing (printing on both sides of paper) according to the type of binding 

for 2-sided-printed pages.

This option is only for printing on both sides of the paper. If you want to bind the output with 

staples, you should set the finishing option as well.

- None — Select this if you do not want to print on both sides of the paper.

- Book — Select this to print on both sides of the paper in the same direction and to bind 

the document along the vertical side of the paper so that the pages can be turned over 

right and left.

- Tablet — Select this to print on both sides of the paper with a vertical reversal and to bind 

the document along the horizontal side of the paper so that the pages can be turned over 

up and down.

y

“Book” or “Tablet” will be automatically selected when the Booklet printing is set at the 

Layout tab.

y

“None” can only be selected when Tab printing is enabled.

1

2

Portrait

1

2

Landscape

1

2

Portrait

1

2

Landscape