Oce im5530 Printing Manual - page 285

Printing with Extended Print Functionality    283

4

If you want to add a margin on the outside edge, enter a width in the 

“Outer Margin” field.

y

You can change the unit of the margin at the “Units” drop down box.

y

The center margin can be set from 0.000 inch to 1.00 inches in units of 0.01 inch 

when the unit is inch, and from 0.000 mm to 25.40 mm in units of 0.10 mm when the 

unit is mm.

The printed images will be reduced according to the margin setting.

5

If you want to double staple the center, check the “Staple Down the 

Center” box.

“Staple Down the Center” is available only when the Saddle Stitch Finisher is installed 

and configured on the Configuration tab.

6

If you want to create a booklet that can be read from right to left, 

check the “Number Pages from Right to Left” box.

7

If you want to print or insert a front cover, check the “Use Front 

Cover” box and then select, at the “Source” drop down box, the 

drawer where the front cover is loaded.  Also, at the “Print Style” 

drop down box, select whether you are inserting a blank cover or 

printed front cover.

Do not print on page — Select this to insert a blank front cover.

Print on both sides of page — Select this to print the first two pages and last two page 

of document on both sides of a cover.

y

When “Automatic” is selected in the “Source” drop down box, the paper is automati-

cally selected according to the printed document size.

y

The last two page will not be printed or printed only one page if there are no remained 

pages or only a last page for the cover.

8

Set other print options you require and click [OK].

9

Click [OK] or [Print] to send a print job.

y

The print job is printed as a booklet.

If a Saddle Stitch Finisher is not installed, the output will not be folded.  But you can cre-

ate a booklet by folding along the center by yourself.