Oce im5530 Printing Manual - page 330
6 Printing from Macintosh
328 Printing from Application on Mac OS 8.6 to 9.x
y
“Exit Tray” is only available when no finisher is installed.
y
“Tray 1” and “Tray 2” can be selected when the Finisher or Saddle Stitch Finisher are
installed.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
- Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
- Short Edge Punch with 180 degree rotation — Select this to create holes on the bot-
tom for the portrait document, or on the left for the landscape document.
This option cannot be selected if a hole punch unit is not installed.
3) Stapling
This sets whether a print job is stapled.
- Off — Select this to print without stapling.