Taylor 8657 Operating Instructions Manual - Section 5
15
Model 8657
Important: To the Operator
Section 5
Important: To the Operator
Item
Description
1
Reset Mechanism
2
Indicator Lights
3
Power Switch
4
Control Buttons
5
Thermistor Control
Power Switch
When placed in the “ON” position, the power switch
allows “SOFTECH” control panel operation.
Reset Mechanism
The reset button is located in the decorative plate
above the “SOFTECH” controls. The reset protects
the beater motor from an overload condition. Should
an overload occur, the reset mechanism will trip. To
properly reset the freezer, turn the power switch to the
“OFF” position. Press the reset button firmly. Turn the
power switch to the “ON” position. Press the word
“WASH” and observe the freezer’s performance.
Open the side access panel to check if the beater
motor is turning the drive shaft in a clockwise (from
operator end) direction without binding.
If it is turning properly, press the word “WASH” to
cancel the cycle. Press the word “AUTO” on both sides
to resume normal operation. If the reset mechanism
should trip again, contact your authorized Taylor
Distributor to resolve the problem of the beater motor
going out on reset.