Taylor 8657 Operating Instructions Manual - page 24
20
Operating Procedures
Model 8657
Step 5
Install the draw valves. Slide the three o--rings into the
grooves on each draw valve, and lubricate.
Figure 9
Lubricate the inside of the freezer door spouts, top and
bottom, and insert each draw valve from the bottom
until the slot in the draw valve comes into view.
Figure 10
Step 6
Install the draw handles. Slide the o--ring into the
groove on the pivot pin, and lubricate.
Figure 11
Slide the fork of the draw handle in the slot of the draw
valve, starting from right to left. Slide the pivot pin
through each draw handle as you insert them into the
draw valves.
Figure 12
Note: Match the color coded buttons on the draw
handles to the color coded buttons on the freezer
above the door.
Step 7
Install the spinner blades. Lubricate the shafts of the
spinner blades.
Figure 13