Taylor 8657 Operating Instructions Manual - page 39
35
Model 8657
Operating Procedures
Figure 78
Step 9
After five minutes, raise the prime plug. Press the word
“PUMP”, and pull down the draw handle. Draw off the
remaining sanitizing solution.
Figure 79
Step 10
Once the sanitizer stops flowing from the door spout,
close the draw valve. Press the words “PUMP” and
“WASH” to stop operation. Disconnect the pressure
line from the pressure switch. Drain the sanitizer and
reconnect.
Priming
To prime both sides of the Model 8657, the steps will
be the same. Therefore, first prime the shake side, and
then go back and duplicate these procedures for the
soft serve side.
Step 1
Sanitize the mix tank, mix tank cover, mix probe and
funnel. Place the mix tank and cover in the mix cabinet.
Step 2
Insert the prongs of the mix probe inside the mix tank.
Connect the mix probe in the socket receptacle.
Figure 80
Step 3
Place the free end of the suction line down in the mix
tank.
Figure 81