Taylor 8657 Operating Instructions Manual - page 27
23
Model 8657
Operating Procedures
Step 3
Assemble the freezer door. Place the large rubber
gasket in the groove on the back side of the freezer
door. Note: Be sure the round edge is against the
door.
Slide the white plastic front bearing over the baffle rod,
making certain that the flanged end of the bearing is
resting against the freezer door. DO NOT lubricate the
gasket or front bearing.
Figure 23
Slide the two o--rings into the grooves on the prime
plug. Apply an even coat of lubricant to the o--rings and
shaft.
Figure 24
Insert the prime plug into the hole at the top of the
freezer door and push down.
Figure 25
Step 4
Install the freezer door. Insert the baffle rod through the
beater in the freezing cylinder. With the door seated on
the freezer studs, install the handscrews. Tighten
equally in a criss--cross pattern to insure the door is
snug.
Figure 26
Step 5
Install the draw valve. Slide the two o--rings into the
grooves on the draw valve and lubricate.
Figure 27