Vacon 100 INDUSTRIAL Applications Manual - page 27
3
vacon • 25
VACON HVAC Drive Application
Tel. +358 (0) 201 2121 • Fax +358 (0)201 212 205
3.5
Vacon HVAC Application - Application parameter lists
Find the parameter menu and the parameter groups as guided below.
The HVAC Application embodies the following parameter groups:
Table 19. Parameter groups
3.5.1
Column explanations
Code
=
Location indication on the keypad; Shows the operator the parameter num-
ber.
Parameter= Name of parameter
Min
=
Minimum value of parameter
Max
=
Maximum value of parameter
Unit
=
Unit of parameter value; Given if available
Default
=
Value preset by factory
ID
=
ID number of the parameter
Description= Short description of parameter values or its function
=
Apply TTF programming to this parameter
=
More information on this parameter available; Click the parameter name
Menu and Parameter group
Description
Basic and advanced motor settings
Frequency reference setup
Group 3.3: Control reference settings
Acceleration/Deceleration setup
Group 3.4: Ramp & Brakes Setup
Start and stop functions
I/O programming
Group 3.7: Prohibit Frequencies
Prohibit frequencies programming
Programmable limit controllers
Protections configuration
Auto reset after fault configuration
Configuration of 3 timers based on
Real Time Clock.
Parameters for PID Controller 1.
Motor control or external usage.
Parameters for PID Controller 2.
External usage.
Parameters for multi-pump usage.
OK
STOP
READY
Keypad
Main Menu
Quick Setup
( 17 )
( 6 )
Monitor
Parameters
( 13 )
ID:
M3
STOP
READY
Keypad
Motor Settings
( 2 )
Start/Stop Setup
( 7 )
References
( 18 )
Parameters
ID:
M3.1