Xerox 4213 User Manual - page 225
SUPPLIES: ORDERING INFORMATION
Memory upgrades
The standard 4213 printer is supplied with 1 MB of random
access memory (RAM), but only 0.5 MB usable. You will need to
upgrade the memory capacity if you plan to use the following
page buffers:
•
One full frame which requires 1.1 MB of RAM
•
Two full frames which require 2.2 MB of RAM
•
One full long frame which requires 1.4 MB of RAM
•
Two full long frames which require 2.8 MB of RAM (two 2
MB memory upgrades).
Additional memory may be required if you wish to use a large
variety of downloadable fonts at the same time. Adding memory
also increases the processing speed of the printer.
Note: Printing of full-page graphics may be limited by the ability
of the host computer to send the full graphic. The 13-page-per-
minute rate of speed for 1-sided printing may be affected if your
host computer cannot send data in the allotted time of 5.45
seconds. If this is the case, you will notice a slower printing
time.
A message is displayed if you have exceeded the memory
capacity of the 4213 laser printer.
Memory upgrades for the 4213 printer are available in one size: 2
MB. The part number for ordering is 2H5.
To purchase a memory upgrade, contact your printer supplier, or
your sales representative.
Note: If you intend to purchase the PostScript emulation, you
should note that this PDL board requires the printer to have 2
Single Inline Memory Module (SIMMS) upgrade, at least 4.5 MB
of RAM.
7-4
XEROX 4213 LASER PRINTER USER GUIDE