Xerox 4213 User Manual - page 399
SIMM KIT INSTALLATION AND REMOVAL INSTRUCTIONS
System controller board reinstallation
10. Place the system controller board into the receiving rails of
the printer.
11. For reinstallation of the system controller board, reverse the
removal process in steps 1 to 6.
Caution: Cable connectors may interfere with the
reinstallation of the system controller board; therefore, route
them carefully.
Removal of SIMM board without replacement
You may choose to remove the faulty SIMM board, but not
replace it. If this is the case, you must rearrange the remaining
SIMM board(s) so that there is no gap between boards.
Note: If there is a gap left between the SIMM boards after
removal of a board, the printer will not recognise any SIMM
boards in the connectors with numbers lower than that of the
connector with a missing SIMM board.
Follow the previous instructions for SIMM board removal and
installation, if necessary.
A5-12
4213 LASER PRINTER USER GUIDE