Xerox 4213 User Manual - page 280
XEROX COAX/TWINAX OPTION
1. Connector J6 for Coax/Twinax board
2. OPTIONAL I-O plate
3. Thumbscrews
4. System controller access cover plate
5. Cable connector J7
6. Cable connector J2
2. Turn the thumb screws counterclockwise until they are loose
and turn freely.
Note: The screws cannot be removed from the bracket.
3. Pull the system controller board out approximately 102 mm
(4 inches) along the receiving rails.
4. Depress the clip to disconnect the cable connector from the
system controller board at J7.
5. Disconnect the cable connector from the system controller
board at J2.
Note: If theconnection is very tight, snug, or stuck, a gentle
back-and-forth and side-to-side rocking motion will help to
loosen it.
6. Lift slightly and pull to remove the system controller board
from printer, and place it on a firm, flat surface.
7. Using the screwdriver provided, remove the screws and the
OPTIONAL I-O plate from the system controller access cover
plate. (Refer to figure A3-5.)
Note: Keep the screws for later use.
XEROX 4213 LASER PRINTER USER GUIDE
A3-9