Xerox 4213 User Manual - page 409
MULTI MEDIA FEEDER
Loading paper
Follow the instructions below to load the MMF with paper.
1.
Move the adjustable guide toward the rear of the machine
and raise the weighted arm.
2.
First fan the paper stack then gently tap the stack on a firm
surface to align the edges of the sheets.
3.
Load the paper short edge into the MMF. Paper should be
loaded curl side down. This is opposite the way paper is
loaded in the paper trays. Insert the media into the MMF
until it meets resistance, making sure all edges are aligned as
shown in figure 3. Refer to chapter 5, “Care and
maintenance,” for more information on paper curl.
4.
Slide the adjustable guide against the stack of paper and
place the weighted arm on top of the paper stack.
Do not load paper above the lower MAX line on the adjustable
guide of the MMF.
Notes: Approximately 6 seconds after loading, the bottom
sheet will prefeed to a ready to feed state.
Your MMF installation is complete.
A6–8
XEROX 4213 LASER PRINTER USER GUIDE